Build Instructions

Collapse

• 1

  Wreath Design

  First, I wanted to make sure that we could do something that looks like a wreath - if we got the electronics working, it wouldn't matter if we couldn't actually make it look like an Advent Wreath. 

  First, we need a green base. The first set of pipe cleaners we got only had one shade of green, and it was a bright neon green shade, so didn't look great. We later went to get a different packet of pipe cleaners that included more of a pine green.

  Next, we needed something that looked like candles. We ended up going with a simple design of twisting a white and colored (either purple or pink) pipe cleaner around a wire, which did a pretty good job of standing up straight.

  Finally, to look like a wreath, my daughters were in charge of coming up with some decorations. They used pipe cleaners to make flowers and leaves that would go on the final product (and would cover up some of the electronics.

• 2

  Electronics Prototype

  While the girls were working on decorations, I got out a breadboard, an Arduino Nano and some electronics components and started figuring out the electronics. 

  One non-obvious snag with dealing with the Arduino Nano was that it required using Linux - Mac didn't have support for the right drivers to hook it up. So I got out my old Linux laptop.

  Obviously, we needed 4 LEDs and resistors. That was an easy part, and mostly followed standard "Hello World" Arduino tutorials.

  I also experimented with adding a button for changing the week. Of course, it's not enough to detect when the input pin goes high and hook that up to a counter, for a few reasons. First of all, when the input pin goes high, it may stay high for several cycles, meaning the counter will end up on a random number. Also, some stray current could make the pin high even without the button pressed. These issues can be solved by adding logic to detect that the button was low, stayed high for a certain amount of time, and then the pin went back down to low again. In the end though, since this was a button that we'd press once a week, it didn't seem worth it to add to the final build.

• 3

  Power

  Before building the full, final product, we needed a way to provide power. I didn't want to rely on it being plugged in, so I decided to hook up a 9V battery. You can get a pack of 10 9V clips pretty cheaply off Amazon. I clipped off the plug head (since I wasn't going to plug it in), used a wire stripper to expose a bit of wire, and did a quick sanity check that I could power the wreath circuit prototype with the Arduino hooked up to the 9V battery instead of my laptop power.

View all 5 instructions