Close

Side two for TPS61090 pcb.

A project log for Ramps 1.4 + Knee and Column kit

A simple machined 11 part kit for DIY PCB fabrication.

jaykenJayken • 11/02/2019 at 02:51•0 Comments

Didn't give enough clearance on some of the pads. Had to get creative to insulate them from the rest of the copper. That was fun.

Previous log

Etching a PCB from a toner transfer made with the KC heat press combo reflow hot plate.

11/02/2019 at 02:48 • 0 comments

Discussions

Yes, delete it Cancel

Going up?

About Us Contact Hackaday.io Give Feedback Terms of Use Privacy Policy Hackaday API

© 2025 Hackaday