ESP(32)-01 Programmer

A simple USB Interface to generate the necessary signals to programm an ESP-01 module with AutoProgram!

Thomas Buck

Following Follow project

Liked Like project

Become a Hackaday.io member

Just one more thing

To make the experience fit your profile, pick a username and tell us what interests you.

OK, I'm done! Skip

Similar projects worth following

View Gallery

Description

The PCB provides the Auto-Program-Feature from the well known ESP-DevKit C and adds it to the cheap available Programmers. It provides a reset button and switches to configure the use of an ESP32 or ESP8266 Module (which require a slightly differing configuration of the GPIO pins) in manual or automatic mode. It is fully compatible with the usual ESP-Idf and ESP-Arduino Programmer Software.
Note: It is a spin-off from the ESP32-01 module.

Details

Note: The shown photos in the gallery show the first revision of the PCB where the PCB-Side was wrong fro the USB Connector. This has been fixed in the Gerber files and schematic shown here.

Files

ESP32-01-programmer_gerber.zip Gerber Files for production x-zip-compressed - 26.23 kB - 01/02/2021 at 14:04		Download
ESP32-01-Programmer.pdf Schematic and pcb details Adobe Portable Document Format - 1.79 MB - 01/02/2021 at 14:04		Preview

Components

1 × FT231XQ FTDI USB to RS232 Converter Chip in a QFN20 Package
1 × LP2981AIM5-3.3 3.3V LDO
1 × PRTR5V0U2F ESD protection of the USB-Port - can be omitted for the brave
1 × BC846S Dual npn-small-signal-Transistors
1 × BAT54CXV3T1G Dual Schottky Diode

View all 18 components

ESP(32)-01 Programmer

Become a Hackaday.io member

Just one more thing

Description

Details

Files

ESP32-01-programmer_gerber.zip

ESP32-01-Programmer.pdf

Components

Enjoy this project?

Discussions

Become a Hackaday.io Member

Does this project spark your interest?

Report project as inappropriate

Send message

Remove Member