RP2040 Stamp

A hand-solderable SMD/TH module w/ RP2040 MCU+8MB FLASH, LDO, LiPo charger, reset btn, and Neopixel. Breaks out all GPIO+USB+SWD+BOOTSEL+RST

Description

The RP2040 Stamp is a hand-solderable SMD/TH module that integrates the Raspberry Pi RP2040 MCU with 8MB of FLASH, an LDO, LiPo charge management (including a charge LED), a reset button, and a Neopixel. It breaks out all the GPIOs as well as USB, SWD, BOOTSEL, RST, and the voltage pins.

At only 1 by 1 inch (25mm x 25mm), the Stamp packs a lot of features:

- 8MB of FLASH
- 500mA 3.3V LDO
- All 30 GPIOs broken out
- A Neopixel
- LiPo supply and charging circuit (with charging LED)
- USB broken out
- SWD broken out
- Reset Button
- 12MHz crystal

Discussions

davedarko wrote 03/28/2022 at 12:33

since twitter is down

https://hackaday.com/2022/03/28/putting-the-rp2040-on-a-stamp/

Are you sure? yes | no

deʃhipu wrote 03/28/2022 at 12:38

twitter is down?

Are you sure? yes | no

davedarko wrote 03/28/2022 at 16:17

was a bit, I was not alone :D

Are you sure? yes | no

marcin.puch wrote 03/11/2022 at 14:12

Hi. Are you planning to add RAM to this project?

Are you sure? yes | no

Martin Cejp wrote 01/30/2022 at 21:12

Omg, this is adorable, and very useful.

Are you sure? yes | no

davedarko wrote 01/30/2022 at 20:15

such soon, much now

Are you sure? yes | no

arturo182 wrote 01/30/2022 at 22:24

I figured if I have HaD in my twitter bio, I should post this here 😅

Are you sure? yes | no

RP2040 Stamp

Become a Hackaday.io member

Just one more thing

Description

Enjoy this project?

Discussions

Become a Hackaday.io Member

Does this project spark your interest?

Report project as inappropriate

Send message

Remove Member