vlkOtto Winter send me STL files with case design for HW v1.0
Bottom part: Weller-RT6-Holder-Bottom-V1.0.stl
Top part: Weller-RT6-Holder-Top-V1.0.stl
Otto Winter send me STL files with case design for HW v1.0
Bottom part: Weller-RT6-Holder-Bottom-V1.0.stl
Top part: Weller-RT6-Holder-Top-V1.0.stl
Discussions
Become a Hackaday.io Member
Create an account to leave a comment. Already have an account? Log In.
Just a quick msg, just tried this on my version (0.3 apparently) and this case doesn't fit as the buttons are on the same side as the display and this is case is for the latter version where the buttons are on the opposite side to the screen :(
Are you sure? yes | no
No, it is not for 0.3 and also not without modifications for v1.1
Are you sure? yes | no
This is a really nice case! I can send the stl I made for my pen too!
Are you sure? yes | no
NOTICE! The case after printing is necessary to clean-up with knife - especially around place where is the display, in other cases you can easily broke the display.
Are you sure? yes | no