Case v-1.0 (v{minus}1.0)

Yes, I know, there is still no news about the case, so, at least something simple....

I try to put this soldering pen into transparent shrinkable tube (ø 10 mm) and seems with very good success, buttons are easy to press, so very good and cheap protection.

.... but one small fail, I forget to put down the protecting foil from the display! ,-D

Discussions

ilium007 wrote 10/31/2018 at 02:22

is there any news on a case design yet ? I’ve seen a few but all seem to lack any sort of mechanical support to take strain off the 3.5mm connector.

Are you sure? yes | no

ivan003003 wrote 07/13/2018 at 13:21

Hi there mr.vlk

I got 1 question about the rt soldering case.

Are you planning to make the case with mr.Otto Winter or you are going to make 1 made by your self ?

Thanks .

http://global-motions.com/ftp/Weller-RT6-Case2.jpg

Are you sure? yes | no

vlk wrote 07/14/2018 at 05:27

Hi Ivan, I working on my own design.

Thanks for asking.

Are you sure? yes | no

ivan003003 wrote 07/14/2018 at 05:51

Ok,thanks you very much :)

Are you sure? yes | no

elektrinis wrote 07/11/2018 at 12:01

Hi vlk,

Nice iron, just bought one.

Can you share a 3D model to print a proper enclosure?

Are you sure? yes | no

vlk wrote 07/13/2018 at 08:56

Thanks for purchasing, 3D model is still not done, some prototype will be soon

Are you sure? yes | no

deʃhipu wrote 07/04/2018 at 00:39

This actually looks pretty good. I wonder if you could just cut some holes in a magic marker, for another improvised case.

Are you sure? yes | no

Selling on Tindie

Manual and link to shop RT tips

Discussions

Become a Hackaday.io Member