Great project!

I have my servo moving using Blynk, but it only works with the Raspberry terminal open.

Also, it does not start automatically on reboot by inserting the code to the rc.local file.

What am I missing?

Thanks

Hello ,

I am getting the below error :

pi@raspberrypi:~/Smartphone-Doorlock $ sudo node doorlock.js
/home/pi/Smartphone-Doorlock/node_modules/pigpio/pigpio.js:137
  pigpio.gpioSetISRFunc(this.gpio, +edge, +timeout, handler);
         

Error: pigpio error -123 in gpioSetISRFunc
    at Error (native)
    at Gpio.enableInterrupt (/home/pi/Smartphone-Doorlock/node_modules/pigpio/pigpio.js:137:10)
    at new Gpio (/home/pi/Smartphone-Doorlock/node_modules/pigpio/pigpio.js:40:10)
    at Object. (/home/pi/Smartphone-Doorlock/doorlock.js:49:12)
    at Module._compile (module.js:570:32)
    at Object.Module._extensions..js (module.js:579:10)
    at Module.load (module.js:487:32)
    at tryModuleLoad (module.js:446:12)
    at Function.Module._load (module.js:438:3)
    at Module.runMain (module.js:604:10)

I am using the RASPBERRY PI 3 with RASPBIAN Installed . Placed the Signal Wire in 14 Slot as mentioned in Code. But I am getting this error. 

Please assist me.

He, please I need you the schematic diagram to connect resistors, servo, etc. Can you publish the shema ?

Hi guys,

Worked through your video instructions. Very good, but can't get doorlock.js to run as it fails to find 'pigpio' module at line 47. As far as I can tell PIGPIO folder is present and populated but the Debian Wheezy os is not handling the call. Any ideas you have would be welcome. Node, nodejs all present, but npm has issues as well. Does that stop your javscript? Other forums I have checked not v helpful so far.

dj