Done with breadboard prototyping

A project log for Bionic Yourself V2.0

Project Bionic Yourself (B10N1C) is a small implant for your arm that makes you a bionic-superhero.

txyz.info • 09/29/2014 at 03:39•3 Comments

Last 3 electronic components was tested with whole system.

HTU21D - humidity and high precision temperature sensor in one IC

MMA8451 - Triple-Axis Accelerometer w/ 14-bit ADC

nRF8001 - Bluetooth Low Energy IC with SPI interface

From tomorrow I'm starting PCB design in Eagle. I'm gonna keep you updated about PCB progress as well.

Previous log

NEW Solution for Arduino Wireless Reset

09/29/2014 at 02:31 • 0 comments

Next log

Improvement for NRF8001 circuit

10/12/2014 at 02:51 • 0 comments

Discussions

Stryker295 wrote 09/29/2014 at 16:21

Why a humidity sensor? Could that act as a hydration sensor, to see how hydrated the body is from the inside? Definitely curious.

Are you sure? yes | no

txyz.info wrote 09/29/2014 at 20:55

Humidity sensor (HTU21D) for safety, if humidity level rises inside enclosure, that means it is time to remove the device.

Are you sure? yes | no

PointyOintment wrote 10/06/2014 at 04:46

Not a biologist, but I imagine that the hydration of the tissue where this will be implanted is regulated by the body, so it would be impossible to measure the whole body's hydration level from there.

Are you sure? yes | no

Done with breadboard prototyping

NEW Solution for Arduino Wireless Reset

Improvement for NRF8001 circuit

Discussions

Become a Hackaday.io Member