The smaller 2 D Trinity Net by the looks of it is up and running. A couple of squeaks but wasn't too bad.

Did notice a couple of possible improvements along the way so will target those next.

Getting this up and running means that I will be able to get an array into the larger FPGA board.

I would prefer to get this all tested out and secure before concentrating on the RS232 again. With that good to go I can start to write some code and get it to deploy to the array.

I've also bought a four line LCD display which will be used by the master to display information. This implies four machines but might be able to use two to a line.

Slow but sure.