Close

Your browser (Internet Explorer) is out of date.

Update your browser for more security, comfort and the best experience on this site.

Update Internet Explorer'

Projects EK likes and follows

130k
568
556
Full-on Spotify scrolling and streaming via a Raspberry Pi Zero W and the original iPod clickwheel. Bluetooth, WiFi, and haptic feedback!!
Project Owner Contributor

sPot: Spotify in a 4th-gen iPod (2004)

guy-dupontGuy Dupont

2.7k
521
19
This device is for automating a timed inflation/deflation cycle for an inflatable vest.
Project Owner Contributor

Automatic Timed Inflation Device

tevianTevian

301
288
5
track the seasons through tele-presence
Project Owner Contributor

Virtual Forest

koen-hufkensKoen Hufkens

19.4k
202
195
Your 3D content on a real PoV volumetric display, no glasses needed!
Project Owner Contributor

VVD: an open source Real 3D Volumetric Display

madaeonMadaeon

7k
96
82
This is the starter guide for the 2022 Hackaday Superconference badge, designed by Voja Antonic.
Project Owner Contributor

2022 Hackaday Supercon 6 Badge Guide

lutetiumLutetium

15.4k
90
88
A very minimal design to break out some common peripherals of the CM4. More a quick demonstration than anything else.
Project Owner Contributor

Minimal Raspberry Pi CM 4 Carrier

timonskutimonsku

6.3k
71
74
Harvesting electricity with the help of moss dwelling microorganisms!
Project Owner Contributor

Moss Microbial Fuel Cell

guru-sanGuru-san

3.7k
66
70
Boo buttons, yaay sharpies
Project Owner Contributor

Supercon 2022 Badge Card Reader

zakqwyzakqwy

6.7k
58
52
monitor the health of trees and fruit
Project Owner Contributor

OpenDendrometer

john-opsahlJohn Opsahl

5.3k
57
50
A new way to generate wind energy using only polyester film based flexible circuits
Project Owner Contributor

Flexible circuit wind generator

stuart-mackenzieStuart MacKenzie

2.8k
56
30
RF is black magic and we're going to learn about it here!
Project Owner Contributor

Remoticon: Basics of RF Emissions Debugging

lutetiumLutetium

55
58
This project uses a phased arrray of ultrasonic transducers to levitate and move a 1mm foam ball to draw in mid-air using the POV effect.
Project Owner Contributor

Volumetric Display using Acoustically Trapped Ball

dan-foisyDan Foisy

5.8k
49
45
This project has everything I like, hardware, software, electronics. It was one of the first projects where I could integrate all of this.
Project Owner Contributor

Cablecam

maximiliano-palayMaximiliano Palay

4.6k
48
43
A flying wing drone that can periodically pull a tether + a generator on the ground that acts like a rowing machine = Flying Wind Turbine
Project Owner Contributor

Kites for Future - Flying Wind Turbine

benjaminBenjamin

3.3k
24
43
Following the normal papercraft workflow, but with PCBs instead
Project Owner Contributor

PCB Papercraft

stephenStephen

2.1k
13
13
A 3D printable servo controllable butterfly valve for my air filter system
Project Owner Contributor

3D printable 125mm butterfly valve

fabianFabian

1.9k
13
12
Track your tasks at your desk when working from home using magnets!
Project Owner Contributor

3D Printed Rotary Time Tracker for Task Management

quincyquincy

656
10
8
A low cost and high efficiency Maximum Power Point Tracking (MPPT) charge controller with multiple inputs for solar panel setups.
Project Owner Contributor

MultiMPPT

leonardo-wardLeonardo Ward

813
8
9
An artificial sunrise lamp to cure morning grumpiness
Project Owner Contributor

Zom-B-Gone!

applied-procrastinationApplied Procrastination

595
7
10
A device which helps you to find your turtle walking in the garden.
Project Owner Contributor

WTF - Walking Turtle Finder v1

danya0x07Danya0x07

1.1k
3
8
An old AC oven motor and a solder iron converted into a wifi enabled tiny Shawarma machine
Project Owner Contributor

Micro shawarma

roni-bandiniRoni Bandini

Going up?

About Us Contact Hackaday.io Give Feedback Terms of Use Privacy Policy Hackaday API

© 2024 Hackaday