0%

0%

Thorsten von Eicken

Imagine, design, build, test, enjoy, repeat!

Santa Barbara, CA

Following Follow me

Send a private message

Similar accounts worth following

Send a private message

GitHub

This user joined on 07/14/2018.

My Projects

Real-time GPS tracker for surfskiing (or kayaking, paddling, rowing) with real-time display as well as LoRa and LTE radios for safety.

Ocean sports fitness tracker

thorsten-von-eicken Thorsten von Eicken

Things I've Built

Esp-link

esp8266 wifi-serial bridge, outbound TCP, and arduino/AVR/LPC/NXP programmer

Projects I Like & Follow

The 2017 Hackaday Prize

A versatile autonomous environmental drone using a buoyancy engine

OSUG: Open-Source Underwater Glider

IP over 430MHz Ham Radio, 50 to 500kbps, 20W RF. Extension for HSMM-Hamnet-AREDN. 100% open-source.

NPR New Packet Radio

The WiPhone project is an open source mobile IP phone. WiPhone is intended to be hackable, modular, cheap, and open, while remaining usable.

ESP32 WiPhone

The 2018 Hackaday Prize

Useful STM32L082-based devices with embedded LoRa radio modem programmable with the Arduino IDE via USB connector, i.e, hackable.

Hackable CMWX1ZZABZ (LoRa) Devices

kris-winer Kris Winer

The 2017 Hackaday Prize

Creating a four legged robot with a running bound gait.

Mr. Runner

alex-martin Alex Martin

Super-small, ultra-low-power 96 MHz Cortex M4F co-processor manages sensors and processes data allowing the MCU host attend to other things.

MAX32660 Motion Co-Processor

kris-winer Kris Winer

The 2017 Hackaday Prize

Visually Programing ESPcopter - ESP8266 based programmable Drone with Visuino

Programing ESPcopter - ESP8266 Drone with Visuino

boian-mitov Boian Mitov

DIY version of the military AS-2259 NVIS antenna for regional comms on HF.

Near-vertical Incidence Skywave Antenna

dan-maloney Dan Maloney

The 2017 Hackaday Prize

IMFR11GHz is a Radio Telescope Michelson Type that operate in 11 GHz, its useful to study extended source objects in the sky

RadioTelescope Interferometer: IMFR11GHz

Hackaday Prize 2019

A 45W Portable USB-Powered Soldering Iron for Makers and Professionals compatible with Weller RT Micro Tips

Solder Ninja Pen

nicolas-schurando Nicolas Schurando

Keeping an eye on the seafloor (especially shellfish)

LoBSTAS: Underwater Camera + Sensor

ellie-t Ellie T

From farm to table

Arduino RC airplane

This project aims to build a 1m autonomous sailing boat to compete in the World Robotic Sailing Championship (WRSC)

Southampton Sailing Robot

Audio pre-amp with radio, OSMC on a Raspberry Pi for media handling.

Multimedia center with DAB/FM radio

terje-io Terje Io

YES, naturally my owning MCU has OLED display.

tiny BLE board with OLED

Modular MCU Platform with decomposed Sections in a M.2 (22/30mm) Formfactor

SNAPZZ - Modular Microprocessor Platform

thorsten-jaeger Thorsten Jaeger

The NOAHCube is the next chapter in my Network of Automated Hardware for home automation. A new centralized and portable automation hub

NOAHCube

Monitor diffuse and global solar radiation. This system moves a fiber-optic cable 0-90 degrees & takes measurements in 9-degree increments.

Installation of Variable-Angle Spectrometer System

View all

Bits

Kris Winer wrote 07/21/2018 at 22:56

Thanks for following my Hackable CMWX1ZZABZ (LoRa) Devices project!

Are you sure? yes | no