.Stack

Need a Marlin firmware and ramps board expert.

mmiscool wrote 07/09/2017 at 02:12 • -1 point

Discussions

Gravis wrote 07/09/2017 at 21:00

I'm a software developer that may be able to help. The only problem is that I don't have a 3d printer or ramps board to test with.

Are you sure? yes | no

mmiscool wrote 07/11/2017 at 02:44

Thanks for troubleshooting with me. It seems there were 2 problems. A need for the gcode sender to reset the printer when it was done and a loose wire on the heater for the extruder. Its working now.

Are you sure? yes | no

bulrush15 wrote 07/09/2017 at 11:49

Have you tried fiverr.com? Or Freelancer.com?

Are you sure? yes | no

mmiscool wrote 07/09/2017 at 15:45

I only wish I had that kind of cash.

Are you sure? yes | no

.Stack

Need a Marlin firmware and ramps board expert.

Discussions

Become a Hackaday.io Member