TestNeoPixel3.ino

The arduino file to run the Neopixel Ring on the trinket.
Its programmed to do one circulation of the LED ring in 6 seconds. During the first minute, 4 leds are red. In the second minute, 8 leds are yellow and after 3minutes are reached, it blinks green. Simply to indicate, that the recommend 180 sec brushing time is reached.

x-arduino - 2.35 kB - 04/19/2016 at 20:45

Download

toothStand4.FCStd

FreeCAD file of the inner base.
The colored parts should simulate the parts (usb charger, trinket, battery, motor)

x-extension-fcstd - 26.48 kB - 04/19/2016 at 20:15

Download

connector.fcstd

FreeCAD file of the part which is mounted on the motor shaft and connects the motor with the tooth brush head

x-extension-fcstd - 27.44 kB - 04/19/2016 at 20:15

Download

tube.stl

3D printer ready file of the outer tube/housing

Standard Tesselated Geometry - 152.23 kB - 04/19/2016 at 20:15

Download

deckel.stl

3D printer ready file of the top part which covers the inner parts and holds the pipe (aka the storage for the tooth brush head (if it would fit ;)))

Standard Tesselated Geometry - 62.09 kB - 04/19/2016 at 20:15

Download

pipe.stl

3D printer ready file of the pipe aka the storage compartment for the tooth brush

Standard Tesselated Geometry - 56.33 kB - 04/19/2016 at 20:15

Download

connector.stl

3D printer ready file of the connector between motor and brush

Standard Tesselated Geometry - 31.33 kB - 04/19/2016 at 20:15

Download