Project | Upgrade your 3D printer from 8bit to 32bit

« Back to project details Sort by:

The first board runs on the customer's printer
06/12/2019 at 07:12 • 1 comment

Thanks Eric! he made this to Geeetech A10 printer so quickly! and waiting for him will update it to his thingiverse. https://www.thingiverse.com/madizmo/about
8 kits are sending out for testing around the world
05/30/2019 at 12:58 • 2 comments

8 kits are sending out for free testing around the world! good luck my babies!
32bit is better than I expected
05/28/2019 at 12:08 • 0 comments
replace the board on the ender3
05/15/2019 at 12:17 • 0 comments
10 prototypes
05/14/2019 at 08:06 • 0 comments

Materials of the last 10 prototypes are prepared for PCB assembly。
New heat sink and PMMA
05/06/2019 at 10:29 • 0 comments

New heat sink and PMMA on the bottom
temperature of the board
04/10/2019 at 04:04 • 2 comments
severval stm32 3D printer board
03/22/2019 at 04:08 • 0 comments
BLtouch auto level
10/04/2018 at 10:45 • 0 comments
S- Curve acceleration test
09/28/2018 at 06:05 • 0 comments