Etching a PCB from a toner transfer made with the KC heat press combo reflow hot plate.

A project log for Ramps 1.4 + Knee and Column kit

A simple machined 11 part kit for DIY PCB fabrication.

Jayken • 11/02/2019 at 02:48•0 Comments

Learning to use the TI TPS61090; Made quicker and cheaper by creating the prototype myself. Used a solution of 2 parts hydrogen peroxide to 1 part muriatic acid. It etched so fast it was like watching frost melt off a hot window. Goodbye forever ferric chloride.

Previous log

Re-use cans for stencils. But how do I flatten the can nicely? With the KneeCol Kit for Ramps 1.4. That's right kids it doesn't just move 3D printers! It also creates up-cycling for your heap of aluminum drink cans!

10/31/2019 at 01:27 • 0 comments

Next log

Side two for TPS61090 pcb.

11/02/2019 at 02:51 • 0 comments

Etching a PCB from a toner transfer made with the KC heat press combo reflow hot plate.

Re-use cans for stencils. But how do I flatten the can nicely? With the KneeCol Kit for Ramps 1.4. That's right kids it doesn't just move 3D printers! It also creates up-cycling for your heap of aluminum drink cans!

Side two for TPS61090 pcb.

Discussions

Become a Hackaday.io Member