| Quantity | Component name | |
| 2 | × | Particle Xenons |
| 1 | × | Adafruit Music Maker FeatherWing - MP3 OGG WAV MIDI Synth Player |
| 1 | × | Female Headers I used these on all of the components as I figured I’d likely scavenge from this project in the near future, since it’s mainly for Halloween |
| 1 | × | Zip-ties (or screws/nails) For the Motion Sensor |
| 1 | × | 4-wire Phone Wire For wiring up the LEDs |
| 1 | × | Heat-shrink tubing |
| 1 | × | Numerous M3x7 screws For Assembling Everything |
| 1 | × | 3D-Printed Components Modified Hypnotoad model with wire routing, Motion Sensor and Controller Enclosures, & Motion Sensor and Controller Enclosure Lids |
| 2 | × | NeoPixel Diffused 5mm Through-Hole LEDs |
| 1 | × | Ultrasonic Distance Sensor - 3V or 5V - HC-SR04 compatible - RCWL-1601 |
| 1 | × | 3xAA Battery Pack For Motion Sensor |
| 1 | × | Toggle Switch For Motion Sensor |
| 1 | × | 300-500 Ohm Resistor For Neopixels |
| 1 | × | 1,000 uF Capacitor For Neopixels (I used a 3k capacitor because that’s all I had handy) |
| 3 | × | Screw Terminals For Neopixels |
Ben Brooks