It just measures temperature. The humidity & barometric pressure are constant. Being a tiny apartment, there's no place for a rain gauge & the only temperature measurements are from a balcony. The temperature readings are bad, but better than wunderground.com. Whenever a lion wants to open a window or go outside, the estimated outside temperature is always right there on the LED panel next to the indoor temperature.
![](https://cdn.hackaday.io/images/5569171620708997297.jpg)
The most expensive part of measuring temperature is the enclosure. Unlike most weather stations which have elaborate stacked air vents & cost a lot, this one used coroplastic, packing tape, & zip ties with a reasonable shot at good airflow with protection from the elements.
![](https://cdn.hackaday.io/images/9439271620873131821.jpg)
It took some doing to isolate the thermistor from the heating of the enclosure.
![](https://cdn.hackaday.io/images/4699831620873281269.jpg)
Instead of a standards based IOT solution, the transmitter is just a PIC with SI4421 radio. It burns 200uA in idle & pulses 30mA every 30 seconds to transmit.
A 2nd Si4421 radio connected to a USB uart & raspberry pi records the data.
![](https://cdn.hackaday.io/images/2642311620873419874.jpg)
Instead of a lipo with charging circuit, the solar panel goes directly into a NiMH through a diode. No over charging worries.
![](https://cdn.hackaday.io/images/6614411620872861494.jpg)
Coroplastic & zip ties are arranged in such a way as to ensure airflow while protecting from rain. This also provided a space for solar panels.
![](https://cdn.hackaday.io/images/2019891620873045795.jpg)
The mane problem is making the weather station last. After 6 months, the packing tape all disintegrated. A more permanent solution was needed. Fortunately, 3D printing had arrived. The internet tends to use lots of hot glue in weather stations, but this all melts.
Nice project!