plan02.jpg

I had to make a precise 1/1 scale drawing of the Sinar camera board/below holding system, because it's impossible to just tape some Swiss made Velcro on a Swiss made camera. To be able to reproduce the very precise mechanical adjustment to hold the below to the camera, and a second one, to hold the digital camera needed to calibrate the shutter.

JPEG Image - 1.52 MB - 04/26/2022 at 09:44

Preview

plan01.jpg

The only sketches I made for that project take only two pages of my notebook.
First page is the lens, and the start of the shutter mechanism.
And there is a screw, with no measures, but I had to write it down.
All the mesures are metrics, because every tool used in France is metric, except the 1/4 and 3/8 screws, unmetric taps and dies are needed.

JPEG Image - 1.40 MB - 04/26/2022 at 09:44

Preview