flatcat ~ your next robot is a pet

We might get pretty close to these :)

We used 3D printing (black and transparent PLA) to create the housing of our robot, of course :)

And in the head module, there is a Raspberry Pi, also pretty obvious :)

For flatcat we wanted smart servo motors to provide the necessary sensor feedback needed for modern robotics controls. But we found only insufficient or too expensive motor solutions, so we created a new motor control board called Sensorimotor.

A Sensorimotor is a distributed low-level DC servo controller networked via a symmetrical bus (RS485) and comes as free-design hardware (see schematics in the files) and free/open-source firmware and middleware (see git repository). Its circuit board is designed so that it fits into standard-sized, low-cost servos in order to replace their original electronics.