Quantity   Component name
1 × A basic 3D-printer that allows modifying the firmware (we use an Anycubic I3 Mega S)
1 × A rigid table of 2m * 80cm or bigger To mount everything on
2 × SBR25 1500mm rail Part of the y-axis
1 × SBR25UU bearings + bearing holders Part of the y-axis
1 × 2,5m glassfiber belt for 3D-printers (often called GT2 belt). 2mm pitch Part of the y-axis
5 × Aluminum profiles of 40x15mm Part of the y-axis
1 × NiCr heating wire of 60 ohm 3A, 5 or 10m length Part of the heated bed
1 × Glassfiber sleeving to insulate the heating wire (resistant to 150 degrees Celsius or more) Part of the heated bed
16 × 8mm threaded rods of 5cm length + 32 nuts for both sides Part of the heated bed
1 × (recommended) Soft glassfiber cloth (50 x 50cm) Part of the heated bed