Starlight Skydome

Description

Almost 500 stars were constructed individually and operated under the power of a coin cell for close to a month. Each star was adhered to the surface of the dome with adhesive, in my case, hot glue. Pay close attention to the threshold voltage across the LEDs, as reasonably priced bulk coin cells only come as high as 3V.

Components

1 × 555 timer
1 × Resistor
1 × Capacitor
1 × PCB
1 × smd LED

View all 7 components

Discussions

gmwatbot wrote 03/12/2014 at 21:24

If using fabric in the future consider sewing/gluing in conductive thread. We did a small area running parallel lines an inch apart which were then alternatively hooked up to + and - to them at the edge. Treat like a flexible breadboard then to power stuff on the fabric with short hookup wires.

Works well for small areas, not sure about a 20ft wall though.

Are you sure? yes | no

Samuel Wittman wrote 03/13/2014 at 16:15

That's a great idea! I'd have preferred to do something like that, except the fabric was already up prior to creating the lights. I'll keep this in mind for next time!

Are you sure? yes | no

BrendanMatkin wrote 02/20/2014 at 00:26

Did they twinkle or something, or just static? Can you post your drive circuit?

Are you sure? yes | no

Samuel Wittman wrote 02/20/2014 at 16:26

They did twinkle, though there was definitely room for improvement in the twinkling behavior. I'll post schematics when I'm not on a mobile device. Thanks for the reminder!

Are you sure? yes | no

Samuel Wittman wrote 02/21/2014 at 20:28

Posted.

Are you sure? yes | no

BrendanMatkin wrote 02/24/2014 at 21:25

Cool, thanks! I always go to microcontrollers for stuff like this and forget that a simple electronic circuit can handle it!

Are you sure? yes | no

mpinner wrote 01/23/2014 at 19:36

brilliant. when's the next setup?

Are you sure? yes | no

Samuel Wittman wrote 01/23/2014 at 21:22

I'm considering redoing the whole project in fiber optics. This quantity of cell batteries proves a bit expensive for a consumable cost each time we set up the dome. The main drive behind batteries was that we didn't have much time, and we didn't want to worry about how we were going to distribute power over the whole thing.

The next installation is going to be a wall indoors as a particle effect, so thankfully I won't have to mount things on a 20ft high concave fabric surface.

Are you sure? yes | no

Mike Szczys wrote 02/22/2014 at 16:40

Hi Sarah,

I didn't see any info on mAh for the batteries you used. But when you mentioned consumables I wondered if you could possibly get away with a super-cap setup? I envision an inductive charging system that puts a stick with a coil on the end of it... like lighting oil lamps of yore, someone would go around each evening and juice up the caps. Whimsical, isn't it?

Are you sure? yes | no

Samuel Wittman wrote 02/26/2014 at 17:44

In response to Mike, because nested replies aren't a thing yet.

The more I think about your idea, the more I like it. I'll have to look into doing that for future installations. I can probably even modify my existing boards, rather than having to buy new ones, which is a huge plus.

Are you sure? yes | no

Starlight Skydome

Become a Hackaday.io member

Just one more thing

Description

Components

Enjoy this project?

Discussions

Become a Hackaday.io Member

Does this project spark your interest?

Report project as inappropriate

Send message

Remove Member