Close
0%
0%

Automatic Irrigation control

What do you do with an automatic irrigation controller that has gone wrong? Put an ESP8266 in it of course.

acuarioAcuario
Following
Liked Like project

Just one more thing

To make the experience fit your profile, pick a username and tell us what interests you.

Pick an awesome username
hackaday.io/
Your profile's URL: hackaday.io/username. Max 25 alphanumeric characters.
Pick a few interests
Projects that share your interests
People that share your interests

We found and based on your interests.

Choose more interests.

OK, I'm done! Skip
Similar projects worth following
157 views
0 comments
1 followers
View Gallery
A few years ago I bought several cheap automatic irrigation controllers for my vegetable garden. Slowly they stopped working, mostly with a 'low battery' fault (new fresh batteries but the controller thought they were exhausted so stopped working).

They are simple devices that run on 3V and have a motorized valve to turn on/off the water. The shaft from the motor to the valve has a cam on it that operates a micro switch to indicate if the valve is open or closed.

The controller can easily be replaced with (in my case) an ESP-08 using one of the GPIO lines to monitor the switch and another via a transistor to operate the motor.

The new controller can be programmed via its own web page and exploits the ESP deep-sleep to give long battery life.

Initially I tried with an ESP-01 but the problem I had was that I needed 2 GPIO lines, one input, one output. The input was fine but the output was a problem as I needed to drive a transistor and the output was being dragged low causing the ESP to hang during reset.

Schematic.pdf

Schematic diagram

Adobe Portable Document Format - 29.22 kB - 09/04/2017 at 11:27

Preview

  • Project progress

    Acuario • 09/04/2017 at 11:33 • 0 comments

    4-September-2017

    It became evident that trying to synchronise time and control by time without using an RTC would be complicated. To keep the unit synchronised it would need to sync to an NTP time server. This would mean connecting to the WiFi and would shorten battery life (the unit is not always in range). This defeated the low power usage.

    As a result I decided to abandon 'real time'. It is, after all, a basic watering system so time of watering and duration isn't that critical. So a new implementation that just sets the watering duration and (approximate) delay between cycles in hours. Also this meand so need to actívate the WiFi RF side so more power saving.

    Software is nearly ready, just a few things to clean up.

View project log

Enjoy this project?

Share

Discussions

Similar Projects

A cheap open-source 4ch wireless ptz alarm controller
Project Owner Contributor

Wireless PIR's + Controller for PTZ Camera

dannyritchiedannyritchie

Upgraded a 6V Lamborghini Power Wheel to a 12V and added traction control that is configurable via WiFi.
Project Owner Contributor

Traction Control Lamborghini Power Wheel

w-jason-alticeW. Jason Altice

GPS Tracker : Arduino based, high autonomy and connected
Project Owner Contributor

High autonomy GPS Tracker

bertrand-lemasleBertrand Lemasle

This is a 3000W inverter based UPS I will use as a backup supply for my server rack, gaming pc and lights
Project Owner Contributor

Franken UPS

dewetDewet

Does this project spark your interest?

Become a member to follow this project and never miss any updates

Going up?

About Us Contact Hackaday.io Give Feedback Terms of Use Privacy Policy Hackaday API

© 2024 Hackaday

Yes, delete it Cancel

Report project as inappropriate

You are about to report the project "Automatic Irrigation control", please tell us the reason.

Send message

Your application has been submitted.

Remove Member

Are you sure you want to remove yourself as a member for this project?

Project owner will be notified upon removal.