Quantity   Component name
1 × NeveRest Classic 40 Gearmotor
1 × RS-380SH DC motor
2 × REV Smart Servo
1 × A lot of 6-32 screws, various sizes
1 × Zipties
1 × A lot of Wire
1 × Old PC Fan Necessary to keep the power supply on
1 × Power Supply with 12v output (5v as well if you want) Mine had a minimum output wattage to stay on so hooking up the fan helped to keep it on
6 × 1/2" Hex Bore, Flanged, Heavy Duty Inner Race Shielded Ball Bearing
2 × Standard Hub Shaft ServoBlock™ (25T Spline)
1 × Any flexible tube to connect feeder to shooter barrel. I used a I used flexible duct pipe, since it was too large of a diameter i cut strips out and folded the pipe into a smaller diameter than used duct tape and zipties to hold it in place. Yes i know... don't judge.
1 × #25 Single Strand-Riveted Roller Chain, 10' Electronic Components / Misc. Electronic Components
1 × L298 Dual DC Motor Controller
2 × Arduino Uno
1 × Proto-Screwshield (Wingshield) R3 Kit for Arduino An extension shield that allows me to access otherwise hidden pins
1 × Nema 14 Stepper Motor At least ~36 oz-in
1 × 1/2 in Aluminum/Steel Hex Axle (~2 feet)
1 × Adafruit Motor/Stepper/Servo Shield for Arduino v2 Kit
1 × RGB LCD Shield Kit w/ 16x2 Character Display