Quantity   Component name
1 × Arduino Microcontroller
1 × Adafruit Motor/Stepper/Servo Shield for Arduino kit - v1.2 Drive the stepper. This is the old stepper sheild I use, new one should work as well
1 × 2 x DC5V 2-phase 4-wire Gear stepper motor 100 to 1 Full Metal Gear Stepper Motor
1 × Joystick
1 × Cables Control cables
1 × Metal sheet To hold it together
1 × Hot Glue Hot Glue to protect stepper inputs
1 × Worm gears and cog wheels Maplin Worns and ebay cogs
1 × Bearings To hold blots while turning and sabilise better
1 × Meccano parts To fasten turning bolts to shelf brackets
1 × 15mm Plumbing Pipe clamps Good for holding the stepper motors
1 × Cheap metal shelf brackets The hold the camera etc...
1 × Super Glue hold the steppers in the 15mm pipe clamps, etc..
1 × Nuts and Bolts washers To hold bearing and springs etc..
1 × 1/4 inch No. 20 Nuts amd bolts Tripod nuts and bolts To hold camera