Quantity   Component name
1 × Module BMS connector Connector is Molex 15-97-5101, pins are 39-00-0038, retaining key is 15-97-9101. http://www.digikey.com/product-detail/en/molex-connector-corporation/15-97-5101/WM4772-ND/1624637
1 × Arduino Due or Teensy 3.2 Both these microcontrollers will operate at the correct UART baud rate and have CAN controllers
1 × MCP2561, MCP2562FD or other CAN transcever only required if interfacing with vehicle CAN bus.
1 × Contactors For pack isolation during power down or fault conditions.
1 × Pre-charge resistor To limit inrush current into DC link capacitance. This will be coupled with a small contactor
1 × Current sensor LEM current transducers are easiest and provide isolation. LF 306-S or similar.