Quantity   Component name
1 × DPS3005 Step-down Power Supply module Voltage converter LCD voltmeter 30V 5A
1 × 24V 120W Switching Power Supply Mains powered 24V 5A power supply
1 × DSO150 Oscilloscope Kit Basic oscilloscope kit for frequencies up to about 100KHz
1 × Voltmeter DC 0-100V Mini LED Digital DC 0-100V Voltmeter
2 × Voltmeter / Ammeter 4 digit DC 0-100V 200V 10A 4 Bit 5 Wires Voltmeter Ammeter
2 × Binding Post Socket 1 pair Red and Black for Voltmeter and Continuity Tester
6 × Binding Post (20A) 3 pairs Red and Black for 5V, 12V/24V, and output of DPS3005
1 × 12V 10A Ceramic Fuse and inline Fuse holder Output of the PSU
1 × ATTINY85 Digispark Board For the continuity tester
1 × 5V Active Buzzer For the continuity tester
1 × 47ohm Resistor For the continuity tester
1 × XT60 Panel Mount Male and Female Plug To connect PSU to MultiBench (1 set)
1 × Barrel Jack Panel Mount 5.5 X 2.1m Optional output connector for DPS3005
1 × DPDT Switch ON-OFF-ON 6A To switch between fixed 12V and 24V outputs
2 × LM2596 DC-DC Adjustable Buck Converter For 24V to 5V and 24V to 12V
1 × Mini DC-DC 12-24V To 5V 3A Step Down (MP1584) Small buck converter to power the DSO150 (24V to 9V)
2 × LM2596S Dual USB Power Supply Module Each with 2A + 1A USB Power Outputs
1 × 2.5mm screws (various sizes) For mounting PCBs and connectors to the case
1 × DPST Power Switch To switch on and off the mains input from the PSU
1 × Slide Switch Panel Mount 3 Solder Lug To switch between voltmeter and continuity tester
1 × 18awg 7.5A Wire (Red and Black)
1 × SPST Switch 3A Used with the PSU to isolate the mains.