Quantity   Component name
1 × TTGO T-BEAM M8N
1 × OLED Display
2 × 12 mm stainless steel waterproof push button (generic, make sure it's momentary)
1 × Upgraded LoRa Antenna (Stock will work but decrease range)
1 × 25mm GPS Antenna (Stock will work but with less reception performance)
2 × Li Ion 21700 (Optional, other li ion cells pouch or even 18650s could work, but who dosen’t want to cram the biggest cell this enclosure will take right?)
1 × Set of male and female XT-30 Connectors (Optional, but these are our preferred battery connectors. Directly soldering to the board will work but is not recommended)
1 × Roll of this silicone wire (make sure its thin)
1 × Roll of thicker gauge silicone wire for battery
1 × Waterproof Panel Mount Micro USB (Generic)
1 × micro usb male breakout (4 pin is possible)
1 × Carbon fiber/Polycarbonate 3D printer filament (PETG or ABS could also work)
1 × RTV Sealer (Most should work, we like JB Weld Ultimate Black)
1 × 5 min Epoxy (Again, we like JB weld)
1 × Painters Tape
1 × 2.7 mm polycarbonate sheet (Acrylic could also work, for our U.S. folks the generic small squares of lexan sheets sold at Home Depot are roughly 2.7mm and should work)
1 × 1 or 2 mm carbon fiber sheet
8 × M3 brass threaded inserts
6 × M3x12 Socket Head Cap machine screws
2 × M3x6 Socket Head Cap machine screws
4 × M3x5 Round head cap machine screws
4 × M3x10 Round head cap machine screws