Instructions | Simple sun position sensor

1

Print the housing
2

glue in the photoresistors

Make sure they are nicely and symmetrically positioned
3

cut the alu sheet to the size.
4

make a pinhole

use the markers in the housing to help you figure out the center. The, use a needle or something like this to make a hole. I have cut the excess material with a wallpaper knife. I have also rolled it flat.
5

sand one side of the cover
6

cover the sanded part with something black

Like a marker or soot
7

glue the cover in

use the markers again to guide you. sanded side to the inside ofc
8

Optional: use the project board and pins to make it clean and accessible

Solder ground wires together. Make sure no wires touch each other. Then connect to pins

Simple sun position sensor