Quantity   Component name
1 × Sparkfun BOB-11400 Electric Imp Breakout Carrier board for Electric Imp
1 × Sparkfun WRL-11395 Electric Imp
1 × Sparkfun PRT-10217 LiPo Charger Basic - Micro-USB LiPo Charger that also had the 5V USB connector and was mighty small
1 × Sparkfun DEV-09904 MinM - Miniature BlinkM I2C RGB controller
1 × Sparkfun COM-10213 N-Channel MOSFET 60V 30A Used to controll the motor driving the clapping arms
1 × Sparkfun PRT-00341 Polymer Lithium Ion Battery - 850mAh LiPo that in hindsight I should probably upgrade to get the life I need
1 × Red, Black, Yellow, White Unicore hookup wire Used the Yellow and White as lines color coded for various data and clocks. Unicore is easy to work with if inflexible
1 × Sparkfun COM-09151 Speaker - 0.5W (8 ohm) Tried all sorts of tiny speakers but in the end used this one to get hearable sounds from the 3.3V PWM
1 × Adafruit i2c / SPI character LCD backpack PID: 292 Gave I/O Expansion without the PWM for motors and eyes
2 × 3300 Ohm Resistors Used to bias the Data and Clock lines on the I2C lines
1 × 1uF Electrolytic Capacitor Used to unsuccesfully smooth the nise from the motor
1 × Micro USB cable for Power
2 × Bags of small glass balls From the local craft shop, used to diffuse the light from the monkey's Blink M shining out of its rear end
1 × Final Touch Brain Freeze Skull Ice Bucket, Glass Filled with glass balls it acts as a seat for the monkey
1 × Large Fake Acrylic Diamond From the craft store. Has the effect braching the Blink M light out into the glass balls
1 × 2.5g Mini Plastic Gear Steering Servo (3.0~7.0V) Operates the mouth
1 × WTV020-SD Micro SD Card Voice Module Used to playback sounds
1 × 4GB Micro SD Card Stores the wierdly formated sounds of the Voice Module
1 × Charlie the Chimp Toy Sort of obvious.
1 × IN1004 Power Diode Flyback diode to prtect the MOSFET when the motor is swtiched off