Quantity   Component name
1 × Raspberry Pi 3 Used to power the early breadboarded version of the project's electronic's components
1 × Raspberry Pi Zero W Used to power the V1 prototype in the "hat" model to register key presses before migrating over to the NTC C.H.I.P. and Pimoroni Picade PCB
1 × Adafruit Arcade Bonnet Used with the breadboarded mock-up and V1 prototype in the "hat" version to register key presses before migrating over to the NTC C.H.I.P. and Pimoroni Picade PCB
1 × 2.5" Color LCD Screen + Driver Board Used as a display monitor in the V1 "hat" prototype of this project
1 × Next Thing Co. C.H.I.P. Used to power the V2 prototype and final version of this project
1 × Lithium Ion Polymer Battery - 3.7v 150mAh Used to keep the cabinet's software from being corrupted by helping power down the C.H.I.P. when power is unplugged
1 × Pimoroni Picade PCB Used to in the V2 prototype and final version of this project to register key presses
1 × 3.5" Color LCD Screen + Driver Board Used as a display monitor in this project
1 × 12V DC Wall Barrel Adapter/Power Supply Used to supply power to the 3.5" screen prior to modifying it in the V2 prototype and final version of this project
1 × 5V DC Wall Adapter/Power Supply Used to supply power the cabinet in all of it's incarnations
2 × USB A male to Micro B male cable 6' Used to connect the power supply to the C.H.I.P. and the C.H.I.P. to the Pimoroni Picade PCB
1 × Thermoplastic Cord Connector Used in conjunction with the 5V adapter and lamp rewire kit to supply power to the cabinet
1 × Antique Bronze Cloth Covered Lamp Rewire Kit Used to supply power from a wall plate to the cabinet
1 × Breadboard Trim Potentiometer - 10K Used to control adjust volume on the V2 prototype
1 × Speaker - 3" Diameter - 4 Ohm 3 Watt Used to play sound in the V2 prototype and final version of this project
1 × Sub-Micro Servo Used to open the back compartment of the cabinet in the V2 prototype and final version of this project
1 × Highpoint Small Box Lock Used to lock the front compartment of the cabinet in the V2 prototype and final version of this project
1 × Mini Joystick Used to control directional movement on the cabinet
5 × Tactile Push Button Switches Used as button switches on the cabinet, and to move the micro servo to the "closed" position in this project when the back compartment is closed
1 × uxcell Repair Momentary Push Button Switch Connector Cable Used to reset the cabinet
1 × 3.5mm TRRS Pigtail Used to pipe out audio and video from the C.H.I.P. to the 3.5" screen and audio amp on the Pimoroni Picade PCB
1 × 3.5mm Male Mono Plug Jack Stereo Audio, Solder Type Used to wire up the TRRS cable audio to the audio amp on the Pimoroni Picade PCB
1 × Red LED Used to signal the correct completion of the cabinet's maze
1 × Hall Effect Sesor Used to activate the LED at the completion of the cabinet's maze
1 × Rare Earth Magnet Used to move the bearing throughout the cabinet's maze
1 × 1/4" Steel Bearing Used to actuate the lever keeping the cabinet's drawer locked