0%

0%

Daniel Adamkovic

Summary cannot be blank, huh?

Slovakia

Following Follow me

Send a private message

Similar accounts worth following

Send a private message

GitHub

This user joined on 05/21/2019.

My Projects

This is a simple H-Bridge board for driving DC motors. It utilizes H-bridge driver IC from TI (DRV8702).

H-Bridge Driver Board (TI DRV8702)

daniel-adamkovic Daniel Adamkovic

Projects I Like & Follow

Hackaday Prize 2019

Homemade 8MHz Z80 SBC, 128kB banked RAM, RTC, SD (HD emulation), Basic and Forth interpreter, CP/M 2.2 and 3, UCSD Pascal, Fuzix and more...

Z80-MBC2: a 4 ICs homebrew Z80 computer

An Odrive + steppers based construction, with 5x 3D printed hollow shaft reducers and an internal CAN network.

Atlas - 6DOF 3D printed universal robot

damian-lickindorf Damian Lickindorf

Hackaday Prize 2019

This wind-up car gift card is fully 3D-printable and is the ideal present for your friends and family.

Fully 3D-printable wind-up car gift card

brian-brocken Brian Brocken

Hackaday Prize 2019

A low-cost, high-performance bipedal walking robot

Blackbird Bipedal Robot

Hackaday Prize 2019

An Off-the-grid messaging system.

Skrypt

Hackaday Prize 2019

The reduction of strain-wave, but using a 'single' stage planetary gearset.

MPRT - Modified planetary robotics transmission

A 3d-printed bipedal robot. A desktop option for semi-direct drive walking research.

TipTap

darren-v-levine Darren V Levine

A compact modular design of the strain wave gear for general robotic applications.

Compact Strain Wave Gear Actuator(s)

A general purpose robot joint using a cycloidal gearbox and an ODrive modified to support active compliance

3D Printed Robot Joint with Active Compliance

tim-wilkinson Tim Wilkinson

An ongoing exploration and experiment about the use of small magnetic loop antennas for QRP (low power) Amateur Radio.

Magnetic Loop Antennas for QRP Amateur Radio

mark-dammer-mm0dqm Mark Dammer MM0DQM

A 65c816-based MiniITX motherboard.

Neon816

lenore-byron Lenore Byron

Hackaday Prize 2019

Convert FPV racing drone into an interceptor using Raspberry Pi

Open Source Air Defense

The 2018 Hackaday Prize

Self-Powered IoT Node for Environmental Sensing

SPINES Mote

Board design which makes it easy to attach LED light strips (APA102). No soldering is required by the maker who is using this board

Board for modular LED wearables

sander-van-de-bor Sander van de Bor

TIRO (Time is Running Out) is a watch that vibrates every few minutes to remind the user that time in this world is quickly running out.

TIRO Vibrating Watch

AccidentalRebel

The 2018 Hackaday Prize

Uses multiple Arduino Nano and a passive mixer to generate multiple voices simultaneously.

Rachel's Nightmare, a distributed polyphonic synth

arduino-enigma Arduino Enigma

Schematic, PCB layout, mechanical CAD, and firmware to create a replica of the DSKY with electroluminescent display

Electroluminescent DSKY replica

ben-krasnow Ben Krasnow

This is a fun project, using simple components to control a maze, without any programming!

Maze controller (only by hardware)

gabriel-despindula Gabriel D'Espindula

View all

Bits