Quantity   Component name
1 × STM32F103C8T6 minimal dev. board (aka "blue pill")
1 × 3.3V USB/Serial adapter I used FT232RL. It's for programming the MCU
1 × 2.4" LCD TFT touch screen display You'll find it by searching "2.4 tft lcd" on eBay
1 × BMP180 For pressure and temperature sensing
1 × A box or enclosure As you might have seen, mine was a pretty toy car
1 × 6-9V battery I used 7.2V li-ion
1 × Small switch Our master switch
1 × 2x2 (square) female header for pin bar For the voltage dividers
1 × 2x2 (square) male pin bar For each of the voltage dividers
1 × LM7805 Power Management ICs / Linear Voltage Regulators and LDOs
2 × 2.2K Resistor To increase impedance of the scope input pins
1 × LM339 Comparator for the inductance meter
1 × 330R Resitor For the inductance meter, as well as everything below
1 × 150R Resistor
1 × 1uF ceramic capacitor The lower the tolerance the better
1 × 1N4007 Discrete Semiconductors / Diodes and Rectifiers