Boris van Galvin-
IOT Air Compressor
10/30/2017 at 00:29 • 0 commentsSome years ago I purchased an old compressor that has been a work horse. A year ago the mechanical pressure switch and contractor's gave out causing the compressor to no longer turn off despite trying to persuade it with a hammer.
I replaced the assembly at a cost of about $120.00
The other day to my dismay the switch failed again, this time it will not turn the compressor on.
Rather than just replace the switching system again I decided to build a new one with some smarts and using an ESP8266, a pressure sensor and a solid state relay I have begun putting together and coding a smart switching system that connected to the local network.
My Projects
My Pages
Things I've Built
Sybian
A sybian is an off the shelf sex machine however they come with plastic gears. I have rebuilt the shaft, changed the expensive bearings for skateboard bearings, replaced the gears and belt with heavy duty ones and modified the controls.
Fucksaw
This is a modified Reciprocating Saw... The trigger has been removed and speed control has been altered in order to alloow for more stable operation. I turned the fitting from Aluminium and the rubber bits are available from shops.
Jacobs Ladder / HV Power Supply
This used 2 automotive ignition coils and initially a set of 2n3055's to drive it however i have since changed the driver to fets. The box also houses 2 12V gell cells and it fun to put on a bar then watch people some up and flick the switch.
My first attempt at a CHC machine.
I have since built another but this one worked well considering it was kind of thrown together from bits and pieces.
The Darwin Gun
This has a Horizontal Jacobs Ladder powered by a 12V battery and a flyback transformer. The end has a UV LED array and some glow in the dark plastic, the valves light up and pulsate and the gauge works.
Pith Helmet
The metal pate with the valves were fabricated and I built a pulsation circuit for the LED's that cause the valves to appear to pulsate. the circuit is based on an op amp and uses a 9V battery inside the helmet.
x-ray ban steampunk goggles
These were originally a set of plastic welding goggles, initially I was just going to cover the plastic in copper but ended up fabricating the entire thing. The only part that is original is the body and that is covered in leather.
Projects I Like & Follow
Kris Winer
Xasin
Nicholas Seward
Paul Andrews
Robin Fröjd
Capt. Flatus O'Flaherty ☠
Dominik Meffert
Generic Default
David Risberg
Morning.Star
A high performance Z-axis that is free of z-wobble and will not drop when power is cut.
Mark Rehorst
Melissa Matos
jeromekelty
ken.do
ekaggrat singh kalsi
Tom Magnier
Mahesh VenkitachalamShare this profile
ShareBits
Morning.Star
wrote 10/02/2017 at 07:54
•
point
Hey Boris, thank you for the skulls and follows, much appreciated :-) I hope you find something useful or inspiring...
Thanks for following my $25 Spectrometer project!