Quantity   Component name
1 × DN80 water sensor 3"
1 × Arduino Uno R3 (clones also work)
1 × HiLetgo 2.4 Inch TFT LCD Display Shield Touch Panel ILI9341 240X320 for Arduino UNO MEGA
1 × length of 3 strand wire (we used silicon copper wire as its really soft and flexible)
1 × 9V battery
1 × set of 3D printed parts From: https://www.thingiverse.com/thing:4700913
1 × Some shrink wrap tubes in multiple sizes
1 × 9V batter mount
1 × Sold
1 × Ranging pole
1 × Switch Development Kits, Boards and Systems / Development Kits and Boards
1 × 3 pin aviation connector
2 × M3 20mm bolts I used stainless steel ones with an allen-key top
2 × M3 nuts I used stainless steel ones
1 × M8 bolt I used a stainless steel one with an allen-key top
1 × M8 Wing nut I used stainless steel one
1 × Silicone I used this to waterproof the sensor inside the DN80 and the wire connections
6 × Wood screws I used stainless steel counter sunk wood screws to hold the arduino housing togeather
1 × Wires to link the housing section I used old off cuts of wire from the DN80.