Close

Recent Projects

There are multiple ways to add floppy-sized storage to the Epson PX-8 or PX-4 computers. PFBDK offers a cheap, easy D.I.Y. solution.
Project Owner Contributor

PFBDK - EPSP floppy drive emulator

fjkraanfjkraan

4S UAV Quad W/ 3D Printed Frame utilizing a Pixhawk 6C Controller
Project Owner Contributor

UAV

rhea-raeRhea Rae

The extension board with switches, buttons, leds, VGA output and general interfaces.
Project Owner Contributor

Evaluation board shield for Tang Nano 9k FPGA

pavelPavel

Leveraging the Programmable Power Supply (PPS) of USB PD 3.0 to make an ultra-compact bench power supply
Project Owner Contributor

PocketPD - USB-C Portable Bench Power Supply

centylabCentyLab

This project documents the progress of my ROS2 rover build. Plans: Mow, sweep, remove weeds in yard, snow removal and spread grit.
Project Owner Contributor

Multi purpose autonomous rover

zarrocZarroc

Automated Pressure Advanced Calibration for FDM 3D printer
Project Owner Contributor

Auto PA for 3D printer

markmark

A scalable multilayer charging station for 18650, and possibly even other battery types.
Project Owner Contributor

18650 Charging Tower

cyplesmacyplesma

Jumperlink is a board designed to make electronic connections easier to set up, maintain, and share compared to traditional jumper wires.
Project Owner Contributor

Jumperlink: A Smarter Way to Connect Electronics

dylan-zhengdylan zheng

BK7258 is connected to 2x2.16" 480x480 AMOLED, one L1+L5 frequency band GPS module, and one SIM7670G 4G module. And 4 sensors.
Project Owner Contributor

BK7258 240MHz+2x480MHz low-power IoT platform

eleclabElecLab

The Dactyl Lynx is a parameterized, split-hand, concave, columnar, ergonomic keyboard - a fork/rewrite of the original Dactyl keyboard.
Project Owner Contributor

Dactyl Lynx

david-h-bronkeDavid H. Bronke

YG's Media Independent Interface, in case your miniMAC is on a different chip than your miniPHY
Project Owner Contributor

YGMII

yann-guidon-ygdesYann Guidon / YGDES

Project designed and 3D printed to simulate and pay homage to those used in the SW saga
Project Owner Contributor

STAR WARS HOLOGRAM

srrubioSrRubio

umac port for ESP32 = System 3.3 with WiFi Connectivity
Project Owner Contributor

Cydintosh

likeabloblikeablob

custom(izable) circuit for sending some megabytes over differential pairs.
Project Owner Contributor

miniMAC - Not an Ethernet Transceiver

yann-guidon-ygdesYann Guidon / YGDES

A system for creating and manipulating plasma, featuring custom parts for generation, control, and dynamic experimentation.
Project Owner Contributor

PCMS

rhea-raeRhea Rae

The G-EDM is an electrical discharge machine that supports sinker EDM, EDM engraving, EDM drilling and Wire EDM operations. #Drahterodieren
Project Owner Contributor

G-EDM

gedm-devgedm-dev

Going up?

About Us Contact Hackaday.io Give Feedback Terms of Use Privacy Policy Hackaday API

© 2026 Hackaday