0%

0%

TheBlinkingMan

Electronics hobbyist. Machining enthusiast.

Following Follow me

Send a private message

Similar accounts worth following

Send a private message

GitHub

This user joined on 10/14/2023.

My Projects

I just want to water my plant, but cheap moisture sensors are pretty bad. Here I attempt to make a better one.

TDR Soil Moisture Sensor

Projects I Like & Follow

A project in which I try to go faster and faster

The Rise and Fall of Pulses

ted-yapo Ted Yapo

A last gasp Uninterruptible Power Supply for any Raspberry Pi computer.

Single SuperCapacitor UPS for Raspberry Pi

bud-bennett Bud Bennett

The 2015 Hackaday Prize

This is an IoT based wireless Home Automation and Security System

Low Cost Wireless Home Automation and Security

sounak-ranjan-das Sounak Ranjan Das

A 2 GHz oscilloscope for everyone

Haasoscope Pro

Turning a 1978 Datsun/Nissan 280z into a future car. Inspired by Night Rider

N.I.T.E (Nissan Industries Two Eighty)

Too simple for a project page & which may never happen.

Silly hardware wishlist

lion-mclionhead lion mclionhead

Smartwatch wearable, ultra-long life measured in years, no need to recharge.

Smartwatch 10 Years Ultra-Long Battery Life

Official Hackaday Prize Entry

Stop wasting time and money on expensive coaxial cable and put the whole radio right at the antenna feedpoint!

Ethernet to Radio Adapter

Universal DSP radio, now with new firmware and SI4732 Chip

DIY Si4732 LW,MW,SW,SSB Radio with 2.8 inch touch

mircemk mircemk

The 2016 Hackaday Prize

Applying polymorphism to hardware enables users to do more with their devices while avoiding IoT pitfalls.

Polymorphic Hardware

trey-german Trey German

The 2017 Hackaday Prize

a professional RS422 / RS485 shield with many options

RS485 / RS422 shield for Raspberry Pi

Replacement PCB for TS100, adds USB-C PD to every hackers favourite tool!

Otter-Iron - TS100 USB-PD hardware mod

jana-marie Jana Marie

An easy to use BLE module for the Raspberry Pi based on the nRF51x chipset

BLEezy: Raspberry Pi Zero

Breakout board intended to secure Raspberry PI or others IoT products thanks to SE050 secure element from NXP

SE050 Security Breakout Board

The 2017 Hackaday Prize

We have 4 Resistors, 4 Capacitors and 1 FPGA to make RADIO Receiver.

4R4C - FPGA Radio Challenge

antti-lukats Antti Lukats

iOmni, is an autonomous (eventually) robot with Lidar to be used as a security system

iOmni

leandro Leandro

An open source highly secure USB dongle for security applications like OpenPGP card or FIDO2

YAST security token

My aim for this project is to create a slightly larger radio telescope, which is able to observe signals on the 21cm hydrogen line

Slightly bigger radio telescope

gonalo-nespral Gonçalo Nespral

View all

Bits

VALENTINE wrote 11/23/2023 at 17:52

Thank you. Cheers! Valentine

Are you sure? yes | no