0%

0%

gustavoriverag

Mechanical engineering student, with interest in computers, mechanical design, digital fabrication and tearing stuff apart :)

Santiago, Chile

Following Follow me

Send a private message

Similar accounts worth following

Send a private message

GitHub

This user joined on 12/21/2022.

My Projects

Implementación de brazo MK2 para recoger objetos en movimiento en una banda transportadora

MKlap2: Pick and place with MK2 arm

Projects I Like & Follow

The 2018 Hackaday Prize

A smaller and cheaper open source brushless motor

PCB Motor

carl-bugeja Carl Bugeja

An Open Source Continuous Inkjet Printer

CIJ Printer

dominik-meffert Dominik Meffert

A functional 3D printable full body exoskeleton - Passive concept development

3X0 - 3D Printable exoskeleton concept

andrea-piccinno Andrea Piccinno

The 567 tone decoder is perhaps most famous Phase Locked Loop (PLL) chip. This project looks at an Arduino software PLL.

Software Phase Locked Loop

agpcooper agp.cooper

A 3D printed stereotax

3D printed rodent stereotaxic device

lex-kravitz Lex Kravitz

The 2017 Hackaday Prize

No more restrictions from high level software! Access the lowest level of radio transmission with this programmable USB stick.

Open narrowband RF transceiver

Two hearts are better than one, so why not have five. Quadcore RPI CM4 and a MCU on a single board for true all-in-one 3D printer control.

Sigmoid S7P 3D Printer Control Board

How I added a 500W heater to my 3D printer to enable reliable ABS printing.

Enclosure Heater for 3D Printer

mark-rehorst Mark Rehorst

A computer built around a Atari 2600 (VCS), with a few nifty upgrades, 6502, 64k + 128bytes ram, coprocessor, 77 is getting a rework

Super atari 6502 (A "DIY" 2600 hardware clone...)

Connect all needed electronics to NodeMCU, add life to them with a help of programming, install HomeAssistant on PC and let's roll!

Home Automation With NodeMCU, HomeAssistant & MQTT

ESP32 runs FabGL to produce VGA display

ESP32 VGA PS/2

land-boardscom land-boards.com

Hackaday Prize 2019

This projects converts a Bobby-Car (children's ride-on toy) to electric by using 4 Hoverboard motors, VESC controllers and an ESP32

Electric Bobby-Car

peter-ptzi Peter Pötzi

A simple pocket-sized projector utilizing an Arduino

DIY Pocket Projector Design

sir-michael-ii Sir Michael II

Fully 3D Printed 6 DOF Arduino Robot Arm

LittleArm Big

Adventures with an Ender 3

How to win at 3D printing

lion-mclionhead lion mclionhead

An open-source dual-channel SDR Raspberry Pi HAT with up to 6 GHz tunable range

CaribouLite SDR for RPI

david-michaeli David Michaeli

Create a monitoring station to measure weather, soil, seismic, solar, magnetic, and gravity conditions - focus best accuracy/dollar w/COTS.

Climate & Environment Monitoring Station

sparksron sparks.ron

Citizen science project with mobile and fixed sensors for measuring air quality using low-cost sensors and smartphones

CanAir.io Air Quality Network

View all

Bits