no wifi - 4 stars ... RTL8188 module and small usb hub with usual suspects
Already have an account? Log in.
To make the experience fit your profile, pick a username and tell us what interests you.
Quick googling seems to make FE1.1S a good choice for a controller.
http://referencedesigner.com/blog/designing-low-cost-4-port-usb-hub/2962/
#PiAngle Zero - Not just another Pi Zero USB Hub
#(One More) Raspberry Pi Zero USB Hub
#RASPICON: Retro Gaming and Media Center Platform
WiFi done with RTL8188 module
call this on a mac in your browser http://beaglebone.local/ - if you get the beagle page, it works! (connecting over usb that is)
ssh debian@beaglebone.local
with password temppwd (you should change that)
sudo iwlist wlan0 scan | grep ESSID
shows you stuff if
sudo iwconfig
shows you stuff if
lsusb
shows you stuff
My wifi and usb hub for the pocketbeagle kinda works now. Little mistake to fix with a bodge wire. @oshpark boards work fine :) I can scan wifi ssids but have trouble with setting up the connection.
Seems like there aren't any capacitors needed for the crystal, although it seems unusual coming from every other chip I've used that needed a crystal. I've added 10pF like in #(One More) Raspberry Pi Zero USB Hub but doubt they're necessary.
Only one extra USB port has a plug, out of size restrictions etc. - a second one has the RTL8188 directly connected. Therefore only one LED is really necessary for the "connected" status.
Added a PRTR5V0U2X as ESD protection for the "external" USB port.
I found my mistake already, had one pin pulled low instead of hig ;) works now, but will check against your design later :) thanks
@Michael Welling @Jason Kridner @Jason Kridner Is there SDIO on the headers? @ajlitt and @davedarko are interested
There is no SDIO broken out on the PocketBeagle except for the microSD card slot.
thanks for clearing that up, would have been great for an ESP12-F WiFi pocketcape.
I haven't looked, but did they bring out SDIO on any of the cape? It would be a shame to waste the only USB host on networking like some other low cost SBC.
I'm working in an USB Hub chip (FE1.1S) as well, not sure about sdio, can't see it on http://www.14core.com/pocketbeagle-mini-computer/ but maybe Drew @oshpark can say more? You're probably talking about doing the same like on #RPi WiFi ?
You read my mind...
I spent a few minutes looking at the pinout and the AM335x datasheet, and it doesn't look like MMC0-2 are represented as alt functions on any of them. Kind of a shame, since the AM335x SoC has 3 SDIO interfaces.
davedarko
hwhardsoft
Andre Cristhian
Andreas Dahlberg
I see you are searching for reference designs - FE1.1s + USB wifi module combo is used in my #raspberry pi zero handheld computer